Footprint
®
Support
1
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
1847179, Revision D
Assembly Instructions
Interworks EQ
®
Panel Mounted
Worksurface
Tools Required
Tape Measure
Drill with torque option
#2 Philips head bit
#2 R-2 square screwdriver bit
Note:
Panel mounted worksurface brackets are provided in two
types, left or right. (Figures A & B). The top of the brackets
should be located 22 3/4 " from the top of the wireway cover
for standard height and 19 3/4" for typing height. (Figure C).
Installation
Figure A Figure B
Figure C
Figure D Figure E
Figure F
Left
1. Insert hook on the top of bracket into the panel frame slot
at a 45° angle. (Figure D).
2. Push the top of the bracket downward allowing locking tab
to engage in the panel slot. (Figure E).
3. Install a bracket at each panel joint in the worksurface
layout.
Note:
When installing the worksurface brackets along the
center, you must alternate left brackets and right brackets to
prevent a shortage of brackets. (Figure F). If you run short of
either left or right brackets, refer to alternate installation
diagram. (Figure G).
Note:
A structural cantilever must be used in place of the
standard worksurface brackets when the open kneespace is
greater than 48" for 1 3/16" surfaces and 60" for 1 9/16" sur-
Right
Figure G
