●
Connect the cone adapter (the most suitable to the transversal section of the tube) to the male connector of the
sealing kit, and the female connector to the positive inlet of the manometer, as below :
●
Isoler l'installation : fermer le robinet du compteur et bloquer les connecteurs fournis à l'installation
Gas meter
Filter and
throttle
●
Connect the cone adapter to the connector downstream the counter.
●
Switch-on the manometer.
●
Inject air or gas to test the installation at the good pressure :
- when feeding with air, pressurize the system with the supplied pump ; once the desired pressure is reached, close
the tap.
- when using combustible or inert gases, close the tap and pressurize the system.
Checking point for new,
renovated and under use
installations
Positive inlet of the manometer
Preliminary operations to use the MP130 manometer with its sealing kit
●
Isolate the installation : close the tap of the counter and block the supplied connectors to the installation.
MP 130
Pump
Cone adapter
