V2.0
27
Notice: Must execute in order, exit automatically if there is no operation in 30s, and users have to start
again. The data input will be valid immediately, but need to be saved by EA00
显示如右图
Command Type
Gear Factor Numerator
Gear Factor denominator
From right to left , each LED represent Load Type, Application,
Limited Switch, Polar of Alarm Output, please refer to Talbe-2
Analog Speed Factor ,Unit is rpm/V
Write
“
1
”
to save all the parameters.
Write
“
2
”
to save all the parameters and restart the servo
Write
“
3
”
to reboot the servo
Write
“
10
”
to initialize the parameters
Notice: Users MUST reboot the driver if changing the motor type
MODE
MODE
SET
Motor Type
LED is blinking
，
Press
MODE can shift
，
the
parameters below
display in the same
way
SET
Confirm the
parameters, the first
dot on the right lighten,
the parameters below
display in the same
way
SET
Long press MODE
SET
SET
SET
SET
SET
SET
SET
▲
▼
▲
▼
▲
▼
▲
▼
▲
▼
▲
▼
Circle
Figure 3-1 Easy flow chart
