21
•
Never leave your child in the seat unattended.
•
It should be noted that any bags and other items must be sufficiently secured, in particular on the
parcel shelf, as otherwise in the event of a collision this can lead to injury.
•
The seat cannot be used without the cover.
•
Do not use replacement covers other than those recommended by the manufacturer, since it is an
integral part of the safety seat.
•
It is recommended to keep the car seat instruction manual for the entire period of its use.
•
Do not use anchorages other than those described in the instruction manual and marked in the child
seat.
•
All rigid items and plastic parts of the child seat must be located and installed in such a way to avoid,
under normal operating conditions of the vehicle, blocking by a sliding seat or vehicle door.
•
Regularly check the technical condition of the harness, paying special attention to the
fasteners/holders, seams and adjustment elements.
•
Discontinue use of the car seat if its parts are damaged or loosened after an accident.
•
In case of an emergency situation, it is important to quickly unfasten the seat belts. This means that
the harness release button is not fully secured; make sure your child knows that s/he is not allowed to
play with the buckle.
•
Do not use the seat at home. It is not suitable for home use and it should only be used when travelling
by car.
•
The back of the seat must rest flat against the back of the car seat. Please make sure that the headrest
does not create an unwanted space between the car seat backrest and back seat of the vehicle. Some
car headrests constitute an obstacle to the installation of a car seat and must therefore be
disassembled first.
•
The adult safety belt buckle must not be located too close to the bottom of the child seat armrest. If in
doubt about this issue, contact the child seat manufacturer.
•
You should give your child a good example and always fasten your belts. An adult with unfastened
safety belts may also be a threat to the child.
•
Before each trip by car, make sure that the seat is properly secured.
•
The car seat must be protected even when not in use. Unattached seat can cause injuries to passengers
even during emergency braking.
4.1 First installation of the seat (Fig. 2)
•
To assemble the seat, insert the headrest in the slot at the top of the backrest (Fig. 2A). The headrest will
snap in the backrest and you will be unable to dismantle it. Hold the backrest and place the two backrest
hooks in the slots in the seat base (Fig. 2B), and place the backrest in the vertical position (Fig. 2C).
To remove the seat base, just move/lean the backrest backwards.
4.2 Seat cushion
NOTE The seat cushion (Fig. 1D) should be used for very small children. The cushion improves comfort and
provides additional support for very small children.
4.3 Height of the headrest
Use the headrest button (Fig. 1C) to adjust the height of the headrest. The height of the headrest can be set
at six levels (Fig. 3).
