GB
Introduction
The CablePort flex is a variable connection system with power and communication sockets for installation in horizontal table tops.
Different installation options:
1.
Installation with the aluminium frame with facet takes place with common tools. A rectangular table section, e.g. with a rail-
controlled hand-held circular saw, is sufficient.
2. Installation with flush aluminium frame is possible at the completed table as well with the corresponding processing of the
tabletop, e.g. with an upper mill and a milling template to be produced in-house.
3. The frameless, flush installation of the basic module into the tabletop requires precise processing of the tabletop when proces-
sing the table, usually CNC controlled.
Tabletops of 15 mm to 40 mm thickness are suitable. For thinner tabletops, the installation point must be reinforced,
for thicker plates, the table top must be cut out in the installation space.
All cutting edges must be protected against entering moisture before the basic module is installed.
All cut-out sizes should be checked with the original parts if possible.
It is recommended to install the basic module without the inserted module carrier and the cable duct cover, and to only insert those
subsequently. In case of narrow spaces, the module carrier can also be inserted in advance according to section 6.
Cut-out sizes are listed in the download area of the respective item at http://shop.kindermann.com
1.
Safety notes
➡
Please read the instructions with care and keep them.
➡
The CablePort flex with Quickselect is operated with 230 V, 50 Hz via a Wieland connection GST 18.
➡
The socket area in the module carrier is not accessible and must not be opened!
➡
The CablePort flex must only be stored and used in dry environments.
➡
Pointed screws and sheet metal may cause injury.
Parts that protrude into the space below the table top may cause injury.
➡
Place all cables without bends; installation radius at least 5 x cable diameter.
➡
Our application-technical notes are given to best knowledge. However, they must be reviewed by specialists and adjusted on
site to the local materials and conditions.
Further claims, e.g. at damage to the tabletop due to non-professional installation, are excluded.
3. Preparing the table cut-out
3.1. Table cut-out for installation with attached
aluminium frame with facet
CablePort flex
Frame outer dimensions
Table cut-out X
Table cut-out Y
Tabletop thickness Z
Basic module 4-fold
7448 000 010
with
aluminium frame
with facet
7448 000 011
271 x 220 mm
257 mm + 1 mm
206 mm + 1 mm
15 - 40 mm
Basic module 6-fold
7448 000 020
with
aluminium frame
with facet
7448 000 021
361 x 220 mm
347 mm + 1 mm
206 mm + 1 mm
15 - 40 mm
Y
X
R4 (4x)
2
2. Scope of Supply
CablePort flex with
• pre-installed cable cover
• pre-installed attachment material
