MAVO Edge 8K Operation Manual (KineOS 7.0)
©2021 Kinefinity Inc.
Page 46 / 61
4.2 Connectors
MAVO Edge 8K brings multiple ports:
Universal ports:
video output (SDI), phantom 48V power input (Standard XLR port), audio input
(3.5mm stereo MIC), audio output (3.5mm stereo headphone), USB-C port, power output (D-Tap),
GENLOCK port, ETHERNET (RJ45) port.
Proprietary ports:
power input (DC IN), LENS port, SYNC port, TC input and output (TC), video
output (Video), high speed extension (EXT1&EXT2), bottom UPS power (EXT3), record trigger (RS).
4.2.1 DC IN
DC IN is located at the back right of the camera body, a 1B 2-pin
push-pull socket. The recommended input voltage of DC is
11V~26V. Please notice the following for a stable workflow:
Max current of external power is 5A;
Max consumption of camera body is 32W;
Max consumption of camera body with KineMON-5U is 38W.
NOTICE
Red dot and groove on the socket should match pin #1.
4.2.2 RS
RS is a 3-pin Fischer push-pull connector for run/stop trigger on
MAVO Edge 8K.
Pin 2: VBAT output is equal to camera body power input
(voltage as 11V~26V), max current up to 3A.
Pin 3: Record on/off input signal, input voltage up to 3.3V.
Shorten pin #3 and pin #1 can trigger on/off.
NOTICE
A combined power output of RS connector and VBAT
on D-Tap is not over 3A.
NOTICE
The input voltage of RS connector cannot exceed 3.3V. Otherwise the camera will be damaged
and be sent to the factory.
#
Definition
1
VDD
2
GND
#
Definition
1
GND
2
VBAT
3
RS
