1981 Wiesbrook Dr
Unit D
Oswego IL 60543
P:630-340-5168
F:815-439-2414
www.kineticfitworks.com
The “3D Sensor” better know as an Accelerometer is a more accurate and reliable recording mechanism
utilizing a multiple vibrating filament as opposed to an old fashion pendulum strike. The “3D Sensor” is
completely silent and does not have a “Clicking Noise”.
The “3D Sensor” allows for 360 degrees of motion giving the unit freedom to be positioned anywhere
accurately recording for all body shapes and users, making the unit nearly 100% accurate.
Where To Position The Pedometer:
The unit can be position anywhere and at any angle on the body (eg. waist, back/front pocket, shoe, purse,
arm, etc.) on the body.
However the ideal position is to clip the unit to your belt or the top of your waistline as near as possible to the
mid-line of thigh. (See Example below)
Step Count:
Press the MODE button until STEP appears on the right. Press and hold the RESET button until a zero
appears; you are now ready to begin walking.
(W4L™ pedometers feature a delayed reset button. Reset Button should be pressed gently with the pad of
finger and held for approximately 4 seconds to clear. The display will flash during the four second interval
to signal that resetting is underway).
If your pedometer is not counting steps, the
Step Filter
may be on. Please refer to instruction below
.
Setting the Step Filter:
(Kinetic Fit Works
™
pedometers feature a delayed reset button. Reset Button should be pressed gently with
the pad of finger and held for approximately 4 seconds to clear. The display will flash during the three second
interval to signal that resetting is underway).
Kinetic Fit Works™ pedometers incorporate a user-adjustable step filter. A step filter counts a specified number
of steps before actually incorporating them into total step count. To set the step filter, follow the steps below:
1. Push the MODE button until you are in step mode.
2. Hold down the SET button for three seconds to switch between ON/OFF. ON = 4 Steps OFF = 0 steps
Switching between U.S. Standard (Imperial) and Metric Units:
Step 1. Press the MODE until the “Mile” screen appears.
Step 2. Press the SET button for 4 seconds to switch between Imperial and Metric.
5 Function Digital Pedometer with 3D Sensor
Kinetic Fit Works / EL-5
Page 1
RESET
BUTTON
MODE
BUTTON
SET
BUTTON
NOTE
60°
60°
30°
30°
