ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
6”- 8” Adjustable wrench or a 1/4” to 1-1/8” combination wrench
set.
ASSEMBLY
1. Attach the 4 caster wheels under the base using 4 pan hd.
screws, washers hex. nuts. Insert the pan hd. screw through
the base and secure with hex. nut, Fig.2 illustrates an
assembled caster.
2. Place the base on all four wheels. Place the motor & housing
assembly on the floor with the motor shaft pointing in the air
(Fig.3). Slide the fan onto the motor shaft until the fan is flush
with the shaft end and tighten the hex. bolt.
3. Remove the three pan hd. screws and washers from the motor
casting (A-Fig.4). Slide the column over the motor casting,
align the holes and secure with the same pan hd. screws and
washers.
FIGURE 2
FIGURE 3
FIGURE 4
