UNPACKING & ASSEMBLY
UNPACKING
Due to modern mass production techniques, it is unlikely that your King Canada
Power tool is faulty or that a part is missing. If you find anything wrong, do not
operate the tool until the parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
1. Remove all loose parts from the carton.
2. Remove the packing materials from around the saw.
3. Carefully lift the saw from the carton and place it on a level work surface.
4. The saw has been shipped with the saw arm locked in the down position. To
release the saw arm, push down on the top of the saw arm, pull then turn the
the saw head release knob (A) Fig.17.
WARNING: Do not lift the saw while holding on to the guards. Use the top
mounted carrying handle.
MITER ANGLE LOCK HANDLE
The saw is supplied almost fully assembled, you should assemble the miter lock
handle (A) Fig.3 first. Attach the miter handle by screwing it into position as
shown. This handle is used to lock or unlock the table at the desired miter angle.
Once the miter angle is set, use the miter lock handle to lock the table.
WARNING! Before making any cut, make sure the miter lock handle is
fully tightened.
MITER TABLE POSITIVE STOPS
There are positive stops at 0
0
, 15
0
, 22.5
0
, 30
0
and 45
0
to the left and right. While
the table is being rotated, the table will stop at the next positive stop. Once the
desired angle is obtained, use the miter lock handle to lock the table.
VISE ASSEMBLY (VERTICAL)
The vertical vise (A) Fig.4 can be installed in two positions on either the left or
right side of the guide fence. Insert the vise rod (B) into the hole in the guide
fence and tighten the vise lock knob (C) to secure the vise rod.
RETRACTABLE EXTENSION WINGS
Before using this miter saw, it is recommended to use the extension wings to
support your workpiece. Simply loosen extension wing lock knob (A) Fig.5, pull
out the extension wing (B) Fig.5 and secure it in place by tightening the
extension wing lock knob (A). Repeat for the other extension wing.
DUST BAG
The dust bag (A) Fig.6 fits into the dust bag adaptor (B) at the rear of the saw
head. For more efficient operation, empty the dust bag when it is no more than
half full. This allows better air flow through the bag.
Figure 3
Figure 4
Figure 6
Figure 5
