LEG & SCREEN ASSEMBLY
5. Attach the 4 foot pads (FOOTPC) to each of the 4 leg pipes (6X6PC) and tighten the eye bolts to secure
them. Lift one side of the canopy and insert the legs into the corner 4-way fittings (see figure #6). Repeat
the step for the opposite side. Now go ahead and securely tie the straps at the corners of the cover as
shown in figure #7. You are now able to use the canopy if you do not want to attach screens at this time
(see figure #7). To attach the screens please continue to the next step.
6. Standing at the exterior corner of the canopy, flip up the corners of the valances until the velcro strip
is exposed (see figure #8). Take a screen wall section and locate the center of it where there is a space
between the hook and loop strip. This is the corner of the screen wall. Hold the wall with the hook and
loop tape facing you and fold it over, attaching it to the hook and loop strip of the valance, aligning the
corner seam of the screen wall with the corner seam of the cover and proceed to attach the screen walls
as shown in figures #9 and 10. Proceed to attach the remaing 3 screens the same way. When all the screens
have been attached you may fold the valances back down and adjust the fit.
7. Connect and close the zippers at the center of each side starting at the top of the screen and
zippering downward. You may have to adjust the screens if they were not properly aligned at the corners.
(See figure #11).
Figure #6
Figure #7
Figure #8
Figure #9
Align
Seams
Fold Hook and
Loop Over and
Attach to the
Cover.
6X6PC
6X6PC
FOOTPC
FOOTPC
