Page 22
2. Connect the 50’ coax cable (that will go to the MAIN receiver) to the coax port labeled
MAIN on the bottom of the dome unit and tighten connection.
MAKE SURE YOU HAVE
REMOVED RIGHT ANGLE COAX CONNECTOR UNLESS YOU ARE RUNNING COAX
OUT TO THE SIDE. (Fig. 14)
.
If using a second receiver, connect a second coax cable (see coax requirements, page 7)
to the unlabeled port and tighten connection.
DO NOT OVER TIGHTEN CONNECTIONS
(Fig. 14).
Note: The Sea-King is wired for multiple receiver support. There are two coax ports on the bottom of the dome
unit. The one labeled “MAIN” must be connected to the main receiver in the vessel. The unlabeled port
can be used for an additional receiver. If using two coax, label the ends of one to avoid confusion when
making the internal hookups.
The installer is responsible for sealing all openings where wiring enters the vessel so they are entirely
waterproof (inside and outside of the holes).
IMPORTANT! You must fill the ends of all external coax (including right angle connectors if being used)
with the supplied dielectric grease. Failure to do so will void warranty.
When configuration and search are successfully completed, disconnect the unit as follows:
a) Turn power off at the keypad.
b) Turn power off at the receiver.
c) Disconnect power.
d) Disconnect coax.
DOME INSTALLATION AND EXTERNAL WIRING
1. Apply foam gasket to bottom of dome unit
(Fig. 13)
.
Fig. 13
Summary of Contents for 1200-KU
