Page 24
INTERNAL WIRING
1. Refer back to your desired wiring configuration and make all permanent connections as
shown, keeping in mind the following important points:
a)
For the permanent installation, use the Wall Mount Controller, not the keypad.
b)
The connection between the dome unit and the receiver must be a direct
connection with no devices in between.
Any other devices should be downstream
from the receiver. Do not go through an “A-B” or any other switch, box, or booster.
c)
Power connection must be a non-shared circuit.
Excessive current draw on the
circuit will cause the unit to operate improperly. Power and ground connections must
be made after the wires are connected to the dome unit.
Use a 7.5 amp fuse in fused non-shared circuits.
FINAL TEST (Follow the Instructions in Section 4, Operation)
1. Perform a search to verify unit is operating correctly. You must be able to view the
program guide or a channel.
Summary of Contents for 1200-KU
