The new channel selected is not found within the currently selected pair.
Press (+) to change the switching pair between 101/110 and 101/119 as
necessary.
Page 29
SYMPTOM
POSSIBLE SOLUTION
Only getting signal on 1/2 of
transponders.
Kinked or sharply bent coax cable.
Verify coax cables are properly terminated with SNAP-N-SEAL
®
connectors only.
Verify receiver is operating properly.
Verify LNB type is set correctly.
Unit never locks on or locks on
and drifts off of satellite.
Atmospheric moisture. Unit will lock on as weather improves.
Check for obstruction in sky in direction of satellite. Select another satellite
and verify unit locks on.
Verify coax cables are properly terminated with SNAP-N-SEAL
®
connectors only.
Perform
OPTION 21 RE-INITIALIZE and 0-RECALIBRATE
(Pages 30-31).
Inspect all coax cables and verify connections are snug but not overly tight
(inside and outside dome unit).
When a channel from the guide is
selected, “Searching for Satellite”
appears on the screen.
The new channel selected is not found within the currently selected pair.
Press (+) to change the switching pair between 101/110 and 101/119 as
necessary.
When a channel from the guide is
selected, a different program
appears on the screen.
For DIRECTV HDTV Programming only:
Summary of Contents for 1500-HD
