KING CRAFT KCT 205 H, Operating Instructions Manual

15

GB

Note the information published by your 
professional associations (VBG 7j).

Switch on the dust extraction system each time 
you use the machine.

Use the saw only with a suitable vacuum 
extraction system or a standard industrial 
vacuum cleaner. 

The bench saw must be connected to a 230 V
socket-outlet with a minimum 10 A fuse.

Never use light-duty machines for heavy-duty
work.

Never use the cable for any purpose other than
that for which it is intended!

Extension cables outdoors: Use only extension
cables which are approved for outdoor duty and
are marked accordingly.

Adopt a firm standing position and keep your
balance at all times.

Check the tool for signs of damage!

Before you carry on using the tool it is imperative
to check that its safety devices and any slightly
damaged parts are working properly and in the
way intended.

Check that the moving parts work properly and
do not jam or whether any of the parts are
damaged. All parts must be fitted correctly and
satisfy all conditions for the tool to work properly. 

Unless otherwise stated in these instructions,
damaged safety devices and parts must be
repaired or replaced by experts in an approved
specialist workshop.

Have damaged switches replaced by a customer
service workshop.

This tool complies with the pertinent safety
regulations. Repairs are to be carried out only by
qualified electricians using original replacement
parts. The user may suffer an accident if this
condition is not observed.

Caution! Risk of injury! Do 
not reach into the running 
saw blade.

Wear goggles

Wear ear-muffs

Wear a breathing mask

Noise emission values

The saw’s noise is measured in accordance with
DIN EN ISO 3744; 11/95, E DIN EN 31201; 
6/93,ISO 7960 Annex A; 2/95. The machine may
exceed 85 dB(A) at the workplace. In this case, 
noise protection measures need to be 
introduced for the user (ear-muffs).

Cutting

Idling

Sound pressure level LPA

105,0 dB(A) 85,0 dB(A)

Sound power level LWA

114,6 dB(A) 94,6 dB(A)

The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immision level
at the workplace include the duration of impact, the
type of room, and other sources of noise etc., e.g.
the number of machines and other neighbouring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved.“

5.  Technical data

Asynchronous motor

230 V 50 Hz

Power rating

720 Watts, S2 30 min

Idle speed n 0

2950 rpm

Carbide saw blade

205 x 16 x 2.4 mm

Number of teeth

20

Table size

513 x 400 mm

Cutting height max.

43 mm

Height adjustment

infinite from 0 - 43 mm

Connector for dust extractor

Ø 35 mm

Size, complete

513 x 400 x 300 mm

Weight:

14 kg

Load factor:

A load factor of S2 30 min (intermittent periodic duty)
means that you may operate the motor continuously
at its nominal power level (720 W) for no longer than
the time stipulated on the specifications label (30
minutes ON period).
If you fail to observe this time limit the motor will
overheat. During the OFF period the motor will cool
again to its starting temperature.