Page 6
EXTERNAL WIRING
6.
Fill end of coax cable that will connect to the MAIN port on the dome unit with supplied
dielectric grease. Connect this end of the coax cable to the MAIN port and tighten connection
(Fig. 5). DO NOT OVER TIGHTEN
.
If using a second receiver, fi ll end of second coax cable with supplied dielectric grease and
connect it to the AUX port. Tighten connection.
DO NOT OVER TIGHTEN.
NOTE:
There are two coax ports on the back of the dome unit. The one labeled “MAIN”
MUST
be connected to the
main receiver in vehicle (DISH model ViP211z, ViP211k, ViP211, or 411 only). This is the receiver that will
control automatic satellite switching. The one labeled “AUX” can be used for an additional receiver (may be
any single tuner DISH receiver - see Section 5 of this manual).
7.
Run the main coax from the back of the dome unit to the roof edge, then along the edge to
the location where it will be fed into the vehicle. If installing an optional second receiver, run
second coax to location where it will enter the vehicle. Secure wiring to roof every 12-18
inches
(Fig. 6)
.
FIG. 5
IMPORTANT! Coax connections should be snug. DO NOT OVER TIGHTEN!
IMPORTANT!
FILL ENDS OF BOTH EXTERNAL
COAX CABLES WITH GREASE.
Failure to do so will void product warranty.
Summary of Contents for Relay KD5500
