background image

INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

We recommend that wherever possible, the Bake-King oven is sited near adequate extraction / 
ventilation to assist with the disposal of steam.

The exterior of this appliance will get hot during operation.  Suitable precautions must be taken.

Make sure that the mains flex cannot come into contact with hot surfaces and that it is adjusted to the 
required length by a qualified person upon installation.  Do not push excess flex under the baker.

If the supply cord is damaged, it must be replaced by the Manufacturer, its Service Agent or Similarly 
Qualified Persons in order to avoid a hazard.

Do not position the baker near to the edge of a counter enabling staff or customers to brush against it in 
passing.

Position the baker so that the electrical socket can be reached easily in the event that the baker needs to 
be disconnected from the electric supply.

OPERATING RECOMMENDATIONS

OPERATING RECOMMENDATIONS

The interior of this appliance will get very hot during operation.  

ALWAYS

use an oven glove 

(preferably one which covers the wrist and lower arm as well) when operating the baker or removing 
potatoes from it.   The handle may got during operation; the use of an oven glove is recommended. 

Take particular care when opening the main oven door; the built-up steam and heat inside will escape as 
soon as the door is opened and could cause injury if you are standing too close. Avoid opening the main 
oven door unnecessarily as this will cause heat loss and lengthen the cooking time.

Handle baked potatoes carefully, occasionally they may burst in the oven or whilst being handled.

Do not turn the thermostat control up to its full setting, as this will invariably burn the outside of the 
potatoes before the inside is cooked; moderate heat for longer is recommended.

All King Edward ovens 

MUST be operated by suitably trained staff

.  Under NO circumstances should 

children come into contact with or operate this appliance.

Taking the trays out and positioning the potatoes before loading will enable you to gain the maximum 
capacity from your baker.

This product may increase the ambient temperature.

Always use best practise and take all reasonable precaution to avoid accidents when using this oven.

INSTRUCTIONS FOR USE

INSTRUCTIONS FOR USE

Before using the oven,  take out the wire trays and position the potatoes on them ready for loading.

Plug the oven in at the socket, turn on the ‘Fan on’ rocker switch in the control panel, this will turn the 
fan motor on and also the display lights.

Turn the thermostat knob on the control panel to the temperature required for jackets we recommend 
190 - 200°C.  At this stage the neon light will come on to indicate that the oven is heating up.

When the thermostat neon goes out, the oven has reached temperature.  You can then load the prepared 
trays of potatoes.  At this stage you may use the timer if you wish by setting it to the desired cooking 
time.  The red neon will then go off when the bell rings at the end of the cooking period.  Please note -
the oven will not automatically turn off!

When cooked sufficiently, the potatoes will feel soft when gently squeezed.  They can then be 
transferred to the top display area and served when required.  To maintain adequate storage temperature 
in the top display area, the main oven must be left on at normal operating temperature (190 - 200°C).

If you intend to cook products other than potatoes, adjust the temperature and cooking times according 
to the product’s cooking instructions - bearing in mind this is a fan assisted oven with reduced cooking 
times. 

Summary of Contents for BAKE-KING








Reviews: