SERVICE SHEET
DISCONNECT FROM ELECTRICITY SUPPLY BEFORE COMMENCING SERVICE
1.
Replacing top oven bulb
Access is gained through top oven door. Lever off glass cover, unscrew bulb - replace
cover ensuring cut-out in cover is over bulb housing side.
2.
Replacing Door Seal (Main Oven)
Lift door off hinges and lie flat with seal facing upwards. Unscrew all screws next to seal,
remove seal and replace. Reverse process.
* Ensure seal is tucked inside lip on cast door and is even all round before fully tightening
screws - do
not
over tighten!
3.
Replacing Top Oven Bulb Assembly
Remove stainless steel oven top, 8 screws, pull off wire connectors. Assembly can be
removed through oven after pushing in clamps around sides. Reverse process.
4.
Replacing Thermal Cut-out
Remove fan motor access panel (2 screws)
–
Remove thermal cut out (2 screws)
–
Replace with new item
–
Reverse process
*
Important
- fibre washers must be replaced between cut-out plate and oven or oven will
cut out prematurely and disable cooking process.
* Test oven at
full
temperature and allow to cycle several times, before leaving. If whole
oven (including lights) go off, cut-off plate would need bending away from oven
- re-test when cooled.
5.
Replacing Main Oven Fan
5.1 Remove element cover from inside oven
5.2 Unscrew central nut anticlockwise, remove fan blade
5.3 Remove fan motor access panel
5.4 Remove thermal cut out
–
Replace with new item. (Ensure fibre washers are used between fan motor fixing
plate and oven wall and also fixing plate and screw heads)
–
Use stud loc and screws to prevent them from vibrating loose.
–
Test oven by turning fan switch on, turn thermostat to mid setting (150-200)
towards neon. Allow oven to cycle several times, making sure fan blade does not
catch on element cover
6.
Replacing Fan Oven Element
6.1 As 4.1
6.2 As 5.4
6.3 Disconnect element connections
6.4 As 5.1
–
Remove element fixing screws
–
Replace with new item and reverse process
–
Test oven
