6
EN
WIL
9
1.4 -
Manual release
01.
Raise the lock cover.
02.
Insert the key and turn it clockwise (
fig. 10
).
WIL
10
1.5 -
Balancing
Correct balancing is essential if the boom gate is going to work prop-
erly.
Rectify balancing only when the bar is mounted and with all the ac-
cessories installed (if any).
Manually release the boom (
fig. 9
- 10
) and adjust the spring tie-rod
(
fig. 11
). The boom is properly balanced when it stays at an angle of
45° without falling or rising. If you are using a very short bar without
any accessories, the power of the spring will be far too strong: in this
case connect the spring to the 2nd hole of the gearmotor output
lever,
fig. 12
.
WIL
11
WIL
12
1.6 -
Adjustments
Slowing down is electronically carried out on the control unit (see
instructions enclosed).
The point at which the bar starts slowing down can be adjusted sep-
arately in opening and closing via the two eccentrics (
fig. 13
).
13
For optimal slowing down, adjust the two stop shock absorbers with
a 19 mm wrench (
fig. 14
).
٨
14
Summary of Contents for OPEN 6000
Page 2: ......
