King gates ROLLS, Instructions And Warnings For Installation And Use

41

EN

5.3 - 

Programming of the button linked 

to the on-board courtesy light

This procedure allows for programming the button of the radio con-

trol linked to the on-board led courtesy light.

STEP

  ACTION

RESULT

1

PRESS THE 

RADIO 

BUTTON FOR 1 SECOND

The red  
"

radio

" LED  turns 

on in the fixed mode

2

PRESS THE 

SET

 BUTTON 

FOR 1 SECOND

The red "

radio

" LED 

remains lit and the 
yellow "

set

" LED 

turns on in fixed 

mode

3

PRESS THE DESIRED 

BUTTON OF ALL THE 

TRANSMITTERS TO BE 

PROGRAMMED

The red "

radio

" 

LED flashes and the 
yellow "

set

" LED 

remains lit in fixed 

mode

4

PRESS THE 

RADIO

BUTTON UNTIL THE 
RADIO LED TURNS 
OFF OR WAIT 20 
SECONDS TO EXIT THE 
PROCEDURE

The red "

radio

" LED 

and the yellow "

set

" 

LED turn off

5.4 - 

Deleting all memorised 

transmitters

This operation deletes all memorized transmitters from the memory.

STEP

  ACTION

RESULT

1

PRESS THE 

RADIO

BUTTON FOR 4 
SECONDS AND RELEASE 
IT WHEN THE RADIO LED 
STARTS FLASHING

The red "

radio

” LED 

flashes (if not, refer to 
Paragraph 14.1)

2

PRESS THE 

RADIO 

BUTTON FOR 1 SECOND

The red "

radio

” LED 

flashes quickly to 
signal the deletion in 
progress

3

WAIT FOR THE END OF 
THE PROCEDURE

The red "

radio

” LED 

turns off

5.5 - 

Deleting a single transmitter

This operation deletes a single transmitter from the memory.

STEP ACTION

RESULT

1

PRESS THE 

RADIO

BUTTON FOR 4 
SECONDS AND RELEASE 
IT WHEN THE RADIO LED 
STARTS FLASHING

The red "

radio

” LED 

flashes (if not, refer to 
Paragraph 14.1)

2

PRESS THE 

SET

 BUTTON 

FOR 1 SECOND

The red “

radio

” LED 

flashes and the yellow 
“

set

” LED turns on in fixed 

mode

3

PRESS A BUTTON ON 
THE TRANSMITTER YOU 
WISH TO CANCEL

The red “

radio

” LED 

flashes and the yellow 
“

set

” LED flashes

4

PRESS THE 

RADIO

BUTTON UNTIL THE 
RADIO LED TURNS 
OFF OR WAIT 20 
SECONDS TO EXIT THE 
PROCEDURE

The red “

radio

” LED and 

the yellow “

set

” LED turn 

off

5.6 - 

Remote (tools free) transmitter 

programming

This procedure enables you to program a new transmitter (“Stylo2K” 
or “Stylo4K”) without accessing the control unit, but keeping close 
to it.
To run the procedure you will require a previously programmed trans-
mitter, to inherite its functions.

ON A PREVIOUSLY 
PROGRAMMED TRANSMITTER, 
HOLD DOWN 

BUTTONS

1

 AND 

2

 TOGETHER FOR

 4

SECONDS

ON THE TRANSMITTER YOU 
WANT TO PROGRAM, HOLD 
DOWN 

BUTTONS

1

 AND 

2

TOGETHER FOR 

4

SECONDS