11) Use extra care when collecting dust on stairs.
12) To avoid injury from accidental starting, unplug power cord before
changing or cleaning the drum plastic bag or the canister filter
plastic bag.
13) Do not use without the canister filter plastic bag in place.
14) Do not unplug by pulling on the cord. To unplug, grasp the plug,
not the cord.
15) Turn off controls before turning off.
16) Do not use with damaged cord, plug or other parts. If your
cyclone dust collector is not working as it should, has missing
parts, has been dropped, damaged, left outdoors, or dropped into
water, send for servicing.
17) Do not pull or carry by the cord, use cord as handle, close a door
on cord, or pull cord around sharp edges or corners. Do not run
your cyclone dust collector over the cord. Keep cord away from
heated surfaces.
18) Do not handle the electrical plug with wet hands.
19) Do not put any objects into the ventilation openings. Do not vacuum
with any ventilation opening blocked, keep free of dust, lint, hair or
anything that may reduce the air flow.
20) Keep hair, loose clothing, fingers and all other parts of the body
away from openings and moving parts.
21) Extension cords in poor condition or that are too small can pose
fire and shock hazards. When using an extension cord, make
sure it is in good condition.
22) Connect to properly grounded outlet only.
23) USE the cyclone dust collector to pick up wood materials only.
DO NOT use to pick up metal shavings, dust, water, or parts.
24) DO NOT handle the plug or cyclone dust collector with wet hands.
cAutIon:
If using this cyclone dust collector to keep airborne wood
dust in heavy usage within acceptable limits, you must regularly
monitor airborne dust and maintain the cyclone dust collector to avoid
exceeding dust limits. Each application is unique. Your maintenance
schedule must therefore be tailored to your specific use.
Safety is a combination of common sense, staying alert and knowing
how your dust collector works.
wArnInG: to AVoId MIstAkes tHAt could result In
serIous, PerMAnent InJury, do not connect tHe
Power cord untIl tHe FollowInG stePs HAVe been
coMPleted:
1) Assembly, mounting and alignment.
2) Learn the function and proper use of the ‘’ON/OFF’’ switch.
3) Read and understand all instructions and operating procedures
throughout the manual.
beFore eAcH use:
1) Inspect your cyclone dust collector. If any parts are missing, bent,
or fail in any way, or any electrical components do not work
properly, turn off the cyclone dust collector and remove the power
cord from the power supply. Replace damaged, missing or failed
parts before using the cyclone dust collector again.
2) Plan your work to protect your eyes, hands, face, ears and body.
3)
weAr sAFety GoGGles. ‘’ForesIGHt Is better tHAn
no sIGHt’’
. Wear safety goggles, not glasses, that comply with
ANSI Z87.1. Operating any power tool can result in foreign objects
being thrown into the eyes which can result in permanent eye
damage.
4) When cleaning the dust collector plastic bags, wear a dust mask.
cAutIon:
The blower housing contains a high speed fan blade that
can amputate fingers, grab loose clothing and neckties, or propel
dust at high velocities.
do not oPerAte wItHout All PArts
In PlAce
.
Do not attempt to clean, remove plastic dust bags or service while in
operation. Disconnect from power source.
sPecIFIc sAFety InstructIons
For your cyclone dust collector
