62
17. Ignition switch
Position of the ignition key is shown in figure.
1."L" LOCK: Insert or remove the key in this position.
2."A" ACC: Power supply of the instrument is switched on
3."O" ON: Normal driving position
4."S" START: Initiating position of the engine, and the key
may rebound to the "ON" position automatically after the startup.
Note:
1. Turn the ignition key to the OFF position after the engine has
been turned off and has stopped running.
2. If the first attempt to start the engine is not successful, please
wait two minutes before trying again.
3. If the engine fails to start after three attempts, check the fuel
supply system. If the vehicle runs on natural gas, check the gas
supply system.
Attention!
1. Do not remove the ignition key while the vehicle is in
movement. And the ignition key should be turned to the
LOCK position only after the engine shut down.
2. When leaving the vehicle, even for a short period, take the key
out to avoid operation of the vehicle by children or
unauthorized persons.
Before starting the engine, turn the key to the “ACC” position
and then to the “ON” position. At this point, three lights (red,
yellow and green) on the dashboard will come on. Wait for the
lights to go out completely before you start the engine. However,
make sure that all of the self-check lights have gone out
completely before starting the engine. Allow the engine to run at
idle speed for three to five minutes after it has been started; but
never let it run for more than 10 minutes at idle speed. If the
vehicle does not move, increase
the fuel to the accelerator modestly to increase the rotational
speed of the engine a little; this will also prevent the early wear
and tear of the engine.
