Technical parameter and complete vehicle description
0-G-2
Driving in kickdown mode
For higher acceleration, depress the accelerator beyond the
full-throttle pressure point. This causes the transmission to
change gears at a higher speed.
Note: Driving in kickdown mode will increase fuel
consumption.
Driving with buttons
1
, 2 or 3
(if available) pressed:
When the transmission hunts between two gears when
driving uphill, press the button for the lower of the two
gears. This will prevent engagement of the higher gear.
Note: Driving with buttons 1, 2 or 3 pressed will increase fuel consumption.
Breaking
With the DIWA transmission breaking is free of wear.
Actuating the brake pedal or the manual switch for converter
brake will apply the converter brake.
Depressing the brake pedal further will apply the service
brake.
Please note when braking on a slippery road: the converter
brake only acts on the driven wheels.
On vehicles without ABS the converter brake should therefore
be disabled when road conditions are poor (e. g. in ice or snow)
in order to avoid rear wheel lock-up and a possible loss of
control over the vehicle.
Switch off the converter brake via the converter brake switch,
if available
Hunting between gears
Pressing the button
4 - 3
3
3 - 2
2
2 - 1
1
Summary of Contents for XMQ6120C series
