Operation Instruction
0-G-3
In vehicles equipped with ABS the converter brake switch is
mostly not availably. The location of switch and its handling
are described in the operating instructions of the vehicle.
Stopping
During short stops (e.g. traffic lights, bus stops) the selected
button remains depressed and the vehicle is held by the vehicle
wheel brake or the parking brake.
ANS-activation
Automatic Neutral at Standstill:
Conditions for activation of ANS :
– accelerator in idling position,
– brake signal,
– driving speed below 1 km/h,
– forward gear selected.
The power flow between engine and transmission is interrupted.
This results in fuel savings.
Reversing
Press button ’R’ while the vehicle is at standstill and the
engine idling and - if available – the reverse gear inhibiter
button. A change from ’Forward’ to ’Reverse’ or viceversa is
only possible after operation of the ’N’ button.
Never engage reverse gear when moving forward – danger of
accident!
Parking
For longer stops or when switching off the engine, switch the
transmission to neutral (button ’N’) and apply the parking
brake.
Summary of Contents for XMQ6900J series
