Operation Instruction
OI-4
Ignition switch
Position of the ignition key is shown in fig.1.
"K" KEY: for inserting and drawing out position of the
startup key
1."L" LOCK: Insert or remove the key in this position.
2."A" ACC: Power supply of the instrument is switched on
3."O" ON: Normal driving position
4."S" START: Initiating position of the engine, and the key
may rebound to the "ON" position automatically after the
startup
.
Before starting the engine, turn the key to the “ACC”
position and then to the “ON” position. At this point, three
lights (red, yellow and green) on the dashboard will come on.
Wait for the lights to go out completely before you start the
engine. However, make sure that all of the self-check lights
have gone out completely before starting the engine. Allow
the engine to run at idle speed for three to five minutes after
it has been started; but never let it run for more than 10
minutes at idle speed. If the vehicle does not move, increase
the fuel to the throttle modestly to increase the rotational
speed of the engine a little; this will also prevent the early
wear and tear of the engine. Allow the engine to run at idle
speed for three to five minutes before turning it off.
Note
：
1. Turn the ignition key to the OFF position after the engine
has been turned off and has stopped running.
2. If the first attempt to start the engine is not successful, please wait two minutes before trying again.
3. If the engine fails to start after three attempts, check the fuel supply system. If the vehicle runs on
natural gas, check the gas supply system.
Attention!
1.
Do not remove the ignition key while the vehicle is in movement. And the ignition key should be
turned to the LOCK position only after the engine shut down.
2.
If engine can not start successfully for the first time, try again after 2 minutes. Please check the fuel
supply system if the engine can not start for the third time.
3.
When leaving the vehicle, even for a short period, take the key out to avoid operation of the vehicle
by children or unauthorized persons.
1
Summary of Contents for XMQ6900J series
