Page
23 of 52
King Pigeon Communication Co., Ltd.
www.iot-solution.com
Wireless Data Acquisition System - LoRa Gateway BL280
4.5 Wireless Node Configuration
Below page is to configure node parameters. Before configuration, the node must be powered
on.Make sure node and gateway are in the same network, i.e. frequency range: default is 1. Once
node is started, it will be shown on the right. Each node has 5 minutes to be configured. If newly
added node is not listed on the right, please restart it. Each node has its own unique MAC address.
Node can be found by its MAC address. There are 12 types of nodes, WT100-WT111. WT100 is
transparent transmission node and the rest are data collection nodes. Below is the example of
configuring WT107 and WT100.
Steps to add multiple-data node WT107:
1. Start node WT107. LED indicator will flicker once and be off. Once it has paired with gateway,
LED indicator will be steady on
2. Find node WT107 on the right and double click it to configure
3. Input node WT107 parameter on the left and click Slave Setting to save it. Once node receives
configuration data, LED indicator will be flickering for 2s
4. After 5 minutes’ configuration, LED indicator will be off and flicker once every 8s.