GSM SMS Alarm & Dialer
GSM SOS Call System!
G S M A l a r m S y s t e m .
14
b) When the wireless PIR Motion detection is PIR-100B, please remember setup the PIR-100B to
Test Mode
while
learning to the K2, after learned to the K2, then please setup to
Normal Mode
by change the Black PIN Jumpers
in the PCB, please see the PIR-100B user manual.
c) The differences of PIR Motion Curtain Motion and Ceiling motion detector are the detection direction areas.
d) When the wireless Detectors is PT2262 fixed IC code, please setup its wireless code by use some Jumpers to
configured it randomly, recommend 4~6 jumpers, see below:
1) Removing the back cover carefully;
2) Locate the IC boards black jumpers, labeled A0-A7 and D0-D3, please see below figure.
3) Configured the A0~A7 and D0~D3 different from each wireless detectors. If configured the A0~A7 and D0~D3
are the same, the system will treat them as the same one sensor. So if you want to add more than one wireless
detector to any zone, please configure the jumpers as the same in the wireless detectors.
4) Also, please check the Resistors value is 3.3M Ohm, there
’re 3 Jumpers, 1.5M, 3.3M, and 4.7M. if you select
incorrect value, the wireless distance usually very short or cannot learn to the K2.
5) Removing wireless accessories.
After learned the wireless accessories to the K2, it can be replaced by learning a new
wireless detector to its position to in stand of it. If you want to remove the wireless detector in
specified position, then please reset to remove all wireless detectors and re-learn the other
wireless detectors again.
6) Some popular wireless detectors
PIR Motion Detector Dual-Element PIR Motion Detector
Ceiling PIR Motion Detector
Door Contact
