Page 11 of 25 Ver 1.0
A Top Safety and Protection Solution In The Worldwide!
Operating method:
[32]
Ö
[XX]
Ö
[#]
XX
indicates: siren sound time, unit “minute”.
Example: Set 5 minutes of siren sound time.
Operating method:
[32]
Ö
[05]
Ö
[#]
LCD display:
6.14 Arm Delay Time Setting
When press down the Away Armed button, the host will arm according to the delayed time after
setting.(If armed by SMS or Remote or phone, no any delay.)
In setup status, enter [33], then input [00~99], press [#] to confirm. The host makes a long beep. A “setting
completed” voice prompt appears.
Operating method:
[33]
Ö
[XX]
Ö
[#]
XX
indicates:Arm delayed time, unit: second.
Example: detailed operating of 2 seconds delayed time arm.
Operating
method:
[33]
Ö
[02]
Ö
[#]
LCD display:
6.15 Alarm Delay Time Setting
Alarm delay time setting is that the host will not alarm until delay timeout.
In setup state, press [34], then input delayed time [00~99] seconds, finally press [#] to confirm. The host
makes a long beep. A “setting completed” voice prompt appears.
Operating method:
[34]
Ö
[XX]
Ö
[#]
XX
indicates:Alarm delay time, unit: second
Example: Detailed operating of 5 seconds alarm delayed time
Operating method:
[34]
Ö
[05]
Ö
[#]
LCD display:
6.16 Telephone Dial-up Cycle Times Setting
Alarm dial-up cycle times are the times of dial-up from the beginning again, if all the phone numbers
are dial-up, but no answer.
In setup state, press [35], then input delayed time [00~99] seconds, finally press[#] to confirm. The host
makes a long beep. A “setting completed” voice prompt appears.
Operating method:
[35]
Ö
[XX]
Ö
[#]
XX
indicates: Telephone dial-up cycle times.
Example: Detailed operating about 2 cycle times.
