Page 13 of 25 Ver 1.0
A Top Safety and Protection Solution In The Worldwide!
***Change Administrator Password
Administrator password is the key to enter the host system when need function setting.
In setup status, use keypad to input [39], then input the 4- digit new password, and then press [#] to confirm.
The host emits will make a long beep and you will hear a voice prompt “ setting completed”.
Operating:
[39]
Ö
[XXXX]
Ö
[#]
XXXX
indicates: the new 4-digit password
Example: change the system password to 2846
Operating:
[39]
Ö
[2846]
Ö
[#]
LCD display:
Note:
The user password and the Administrator password cannot be the same.
6.20 Keypad lock setting
In setup state, press [40], then input [0~1], finally press [#] to confirmed. The host makes a long beep. A
“setting completed” voice prompt appears.
Operating:
[40]
Ö
[X]
Ö
[#]
X=“0”
indicates: Keypad unlock .while Arm/Disarm/Stay by the keypad will not require enter
password.
X=“1”
indicates: Keypad lock. While Arm/Disarm/Stay by the keypad, will require enter
password.
Example: Open the keypad lock function.
Operating:
[40]
Ö
[1]
Ö
[#]
LCD display:
6.21 Timing Function Setting
In setup state, press [41], then choose on/off timing Arm or Disarm function key
[
1/0
]
, finally press [#] to
confirm, The host makes a long beep. A “setting completed” voice prompt appears. Factory default
closed.
Operating: [41]
ٛ
[1/0]
ٛ
[#]
X=“0”
indicates: close all timing Arm/Disarm function.
X=“1”
indicates: Open all timing Arm/Disarm function..
Example: Indicates: Open all timing Arm/Disarm function