10
RDPR-HP-1 User’s Manual
duPLeXeR oPtIon (LZA3015 oR
LZA3017)
If the RDPR-HP-1 is used as a fixed frequency
repeater and one antenna is desired, duplexer
option LZA3015 (VHF) or LZA3017 (UHF) can
be ordered. (Factory install ONLY.)
If a duplexer is installed, the antenna is
connected to Antenna Port 2. If no duplexer is
installed, the antenna ports on each side of the
case are to be used.
To disconnect the duplexer and use the two antenna ports, perform the
following steps:
Remove the two radio mounting plates.
1.
Remove the eight hex screws of the top panel.
2.
Carefully tilt the top panel from the front to gain access to the
3.
duplexer.
Remove the antenna cable from the duplexer and from Antenna
4.
Port 2.
Remove the “RX” and “TX” antenna connection from the duplexer
5.
and re-connect to the respective RDPR-HP-1 antenna ports.
duPLeXeR sWItCh oPtIon (LZA3050)
If the RDPR-HP-1 comes with duplexer option LZA3015 (VHF) or
LZA3017 (UHF), the LZA3050 Duplexer Switch can be ordered. (Factory
install ONLY.)
If the duplexer switch is in the on position (activated), the antenna is
connected to Antenna Port 2. If the duplexer switch is in the off position
(deactivated), the antenna ports on each side of the case are to be
used.
Antenna
Receiver
Transmitter
RDPR
Antenna
Port 2
Radio 1
Antenna
Radio 2
Antenna
RDPR
Antenna
Port 1
Duplexer
Setup
Non-Duplexer
Setup
