8
RDPR-HP-1 User’s Manual
LInKInG (LInKCRdPR2)
The RDPR-HP-1 can be used for Linking using the LINKCRDPR2 cable
with a BK mobile or GBH/DBH base station.
When a valid receive signal is received on the primary receiver (Radio 1),
the primary transmitter (Radio 2) and the mobile/base station will transmit
the received audio.
When a valid receive signal is received on the mobile/base station, the
primary transmitter (Radio 2) will be transmitting the received signal.
Connect the DB15 connector
1.
of the MECRDPR2 into the
accessory port at the rear of
the mobile or base station and
connect the other end to the
Mobile Extender/Link Port of
the RDPR-HP-1.
Switch the RDPR-HP-1 main
2.
power and repeater power on.
Switch the mobile or base
3.
station power on.
Refer to the Mode Settings (page
12) for linking options.
sInCGARs (sInCGARs_LInK2)
The SINCGARS Link Cable (SINCGARS_LINK2) is used to connect
RDPR-HP-1 to SINCGARS radios.
Please refer to Mobile Extender and
Linking sections on page 9 for further
instructions.
RDPR-HP-1
Mobile Radio
LINKCRDPR2
Mobile Extender/Link Port
Accessory Jack
Radio
Power
Supply
RDPR-HP-1
SINCGARS Radio
SINCGARS_LINK2
Mobile Extender/Link Port
Radio
Power
Supply