READ ALL INSTRUCTIONS BEFORE USE
• Study, understand, and follow all instructions before operating this device.
• Failure to heed these markings may result in serious personal injury and / or property damage.
• Prior to each use, visual inspection shall be made to the device by checking for abnormal conditions,
such as cracked welds, leaks, and damaged, loose, or missing parts.
• Do not exceed the rated capacity stated.
• Use only on hard level surfaces.
• This item is to be used as a lifting device only. Immediately support the vehicle with appropriate rated
jack stands after lifting.
• Do not move the vehicle while it is on the jack.
• Lift only on areas of the vehicle as specified by
the vehicle manufacturer.
• No alterations shall be made to this product.
ASSEMBLING THE JACK
The jack is completely assembled except for the handle (4). The handle (4) has two sections, an
upper section with a rubber grip and a lower section with lock screw (3).
1. Remove the hook preventing the yoke (8) from moving to an upright position.
2. Remove the lock screw (3).
3. Slide the lower section into the upper section of the handle.
4. Affix the two parts of the handle by replacing the lock screw.
5. Loosen the handle socket lock screw (1) located in the yoke (8).
6. Apply a small amount of grease to the handle socket inside the yoke (8). Place the assembled
handle into the socket. Line up the square hole at the bottom of the handle over the square bolt
inside the yoke (8).
7. Tighten the handle socket lock screw (1) and ensure that the handle is properly engaged in the
handle sleeve.
KT NO.
Capacity (T)
Min height (mm)
Max height (mm)
9TYT133-25A-B
2.5
75(3
"
)
505(19-15/16
"
)
KT NO.
Capacity (T)
Min height (mm)
Max height (mm)
