1
CONGRATULATIONS,
You have purchased a carefully engineered, quality product built in the United-States!
Your Jump Starter is designed to give you the best quality and convenience you expect
from a professional Jump
Starter. We have taken numerous measures in quality control and in our manufacturing processes to ensure that our
product arrives in top condition, and that it will perform to your satisfaction.
IMPORTANT NOTES
:
READ THE ENTIRE MANUAL BEFORE USING THIS PRODUCT.
IF SOMETHING IS NOT CLEAR CONTACT YOUR RETAILER
.
CHARGE JUMP STARTER 12 HOURS PRIOR TO FIRST USE.
LEAVE CONNECTED TO THE SUPPLIED AUTOMATIC CHARGER WHEN NOT IN USE.
1.
IMPORTANT SAFETY INSTRUCTIONS
1.
Wear safety goggles, gloves and appropriate clothing during each use. Use in a well-ventilated area.
2.
Use of an attachment not recommended or sold by the Jump Starter’s manufacturer, may result in a risk of damage
to the unit/engine, or injuries to people.
3.
When using the charger or charging cable, pull on the plug and never on the wire when disconnecting.
4.
Do not recharge the Jump Starter with a damaged plug or cord. Replace the broken part immediately (see point 2).
5.
The Jump Starter can be used under any weather condition (rain, snow, hot or cold weather), but has to be stored in a
climate controlled place.
Cannot be submerged in water.
6.
Never bring the red (+) and the black (-) clamp into contact or allow them to contact the same piece of metal to
avoid any short-circuit, and to avoid injury or damages.
7.
Do not operate in an explosive environment and / or with flammables, such as gasoline, gas etc.
8.
Do not try to repair the Jump Starter yourself when defective, but have it always repaired by the manufacturer or
your distributor (otherwise warranty will not be given).
9.
Do not try to jump start your car if the battery is being charged. Disconnect chargers before.
10.
Never connect a 12V DC jump starter to a 24V DC vehicle, or the opposite. It may explode and cause damages and
harm you or people around you.
11.
Lead-acid batteries create explosive gases during operations
, it is why you should read carefully this notice. Do
not smoke, use lighters or matches around batteries.
12.
If battery is leaking, do not use the booster and return it to your retailer for repair. Never attempt to repair it yourself,
it may cause injury and void the warranty.
13.
Never leave the Jump Starter too long without recharging it. Severe damages caused by this are probably not
repairable.
IMPORTANT: When the Jump Starter is not in use, always keep it connected to the supplied AUTOMATIC
Charger. The charger will stop automatically when it detects a full battery.
2.
TECHNICAL SPECIFICATIONS
1.
Type of battery: sealed, non spillable, lead acid battery with solid electrolyte (AGM) according the I.A.T.A
standards.
2.
Automatic charger with smart circuit which allows leaving the unit in charge continuously without damage.
3.
12V exit (cigar lighter socket), protected with an automatic reset breaker of 20A, to be connected to all sorts of 12V
accessories or to charge the Jump Starter. (
Caution: 24V sockets only for the 24V models
)
4.
Fully isolated clamps and pure copper cables (super flexible).
5.
Test button and LEDs, digital or analogue display, to check the charge of the battery from 25% to 100%. For a
complete test, press test button for 5 seconds.
6.
Surge protection.
Summary of Contents for Mighty Seven FA-1214
Page 7: ...6 Notes ...
