background image

 

 

TROUBLE SHOOTING: 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

FREQUENTLY ASKED QUESTIONS: 

 
 
 
 
 

 
 

 
 
 
 
 
 
 

 

 
 
 
 

 

       

 

 

 

 

 

 

 

 

 
 
 

PROBLEM 

SOLUTION 

One or two LEDs come on, charger is 

plugged on for 24 hours and there is no 

change in status of other LEDs. 

Check if charger is charging. Charger should be 

warm. Also check if the fuse inside the cigar 

lighter plug of the charger is not defective. 

Charger works well but the Jump Starter is 

not being charged. 

Possible defective battery or faulty internal 

breaker. Try using a device (for example a 12V 

light) with a cigar lighter plug to see if it works. 

Should it work, internal breaker is OK and the 

battery is the problem. 

No LED’s come on, but when the charger is 

plugged into the Jump Starter all the LED’s 

come on. 

Defective battery. 

The Jump Starter is fully charged but has no 

power. 

Check if the cables are well connected to the 

clamps and make sure the jaws of the clamps 

are properly connected to the battery terminals. 

Vehicle battery may be damaged 

When connecting a 12V accessory through 

the cigar lighter outlet on the Jump Starter, I 

heard a clicking sound. 

The plug on the accessory may be defective 

causing the automatic fuse to go off. 

The Jump Starter is equipped with 1 or 2 big 
fuses and is fully charged, but has no power. 

Check if the 500A fuse on the negative side of 

the Jump Starter is OK. If not, please replace it 
with the spare fuse. On some models, the spare 

fuse is installed on the positive side of the Jump 

Starter. This fuse has no function other than to 

serve as a spare part. 

When you hear the buzzer or notice that the 

red warning light is flashing. 

Disconnect the clamps immediately and 

reconnect the clamps on the correct battery 

poles!!!! 

QUESTION 

ANSWER 

How many jump-starts can a fully charged Jump 

Starter do before needing to be recharged? 

1 to 30, depending on: temperature, general 

condition of vehicle, engine type and size. 

Can the Jump Starter’s battery be replaced? 

Yes, contact your nearest distributor. 

Can the Jump Starter be recycled? 

Yes. The environment was one of our main 

concern in the development of the Jump 

Starter. Most battery outlets should recycle this 

product at its life’s end. 

What is the ideal storage temperature of the 

Jump Starter? 

Room temperature. The Jump Starter will also 

operate at cold temperatures; however its 

power will be reduced. Higher temperatures 

will increase self-discharge time. 

I have a regular 10 amps battery charger, can I 

use it to recharge the Jump Starter. 

No, only the originally supplied fully 

automatic charger can be used. 

Is the Jump Starter a general public product? 

No, our models are designed for professionals. 

User manual must still be followed carefully. 

Please dispose of packaging for the product in a 
responsible manner. It is suitable for recycling. 
Help to protect the environment, take the 
packaging to the local amenity tip and place into 
the appropriate recycling bin. 
 

 

Never dispose of electrical equipment or batteries in 
with your domestic waste. If your supplier offers a 
disposal facility, please use it or alternatively use your 
local amenity tip and dispose in a correct manner. This 
will allow recycling of raw materials and help protect 
the environment. 

Summary of Contents for Mighty Seven FA-1214









Reviews: