Page 4
INTERIOR ENCLOSURE INSTALLATION (FIG. 3)
1. Press knob button and remove knob from enclosure base.
2. Make sure the coax exits the roof thru the enlarged portion of the roof hole and route the coax thru the coax hole in the enclosure
base. Place the enclosure base around the adjustable connector and against ceiling. (The enclosure base will seat around the
raised circle on the adjustable connector.) Fasten the enclosure to the ceiling with four included screws.
3. Press the knob button and push knob onto the end of the adjustable connector. (
The knob only fits on the end of the
adjustable connector in one direction
. Knob fits into the raised ring on the enclosure.) Fasten knob to connector with screw.
4. Route the coax around the raised ring as shown and connect the coax to the RF connector on the KING SureLock signal meter.
5. Optional: If desired, apply the decal to the enclosure cover.
6. Carefully align the cover and snap into place. Make sure not to damage or bend LED lights or pinch the coax cable.
IMPORTANT! The rotation knob only fits on the end of the adjustable connector in one direction. SEE INSET BELOW.
FIG. 3