HOW TO USE
This Callous Remover is designed for smoothing coarse skin on the feet and heels
,Do not use this device anywhere else on the body.
1. Wash and clean the skin and dry fully. Note : Do not use on broken or bleeding
skin.
2.Make sure the Rollers Grinding Head is placed into the unit. See section of
Changing the Rollers Grinding Head on
how to remove and replace head.
3. Remove the protective cover from the unit and it is ready to Use.
4.Turn on the unit by pressing the safety switch Sock, in the center of the On/Off
switch, and at the same time push the
switch up (fig. 6).
5.Gently rotate (back and forth or side to side)(fig.7)the callous/corn/hard skin area
for 2-3 seconds. Dot not press
hard-gently glide the unit over desire area. The unit will stop if it is press too hard
on the skin. Stop and check if you have
achieved the softness you desire. If not, go over the area for 2-3 more seconds
and check again. Continue to use this method until the level of smoothness is
obtained.
Warning: stop using if skin becomes sore or Inflamed.
Warning: Do not use on skin for more than 2-3 seconds at a time.
5. Turn the unit off (fig 8).
6. Rinse the skin or use a wet towel to get rid of the excess dead particles.
7. To clean this Callous Remover, please see the Cleaning section.
8. Keep the protective cover on your unit when it is not in use.
