Page 14
TROUBLESHOOTING
The KING WiFiMax doesn’t power on (no blue lights on front).
Make sure power supply plug is securely inserted into back of KING WiFiMax. Make
sure the power supply is plugged into a known good power outlet.
Make sure your KING WiFiMax is plugged in. It may take up to a minute for these
networks to appear. Some older devices may be unable to see the 5GHz network.
This is completely okay; just use the KING_XXXXXX network.
Make sure you are connected to your KING WiFiMax’s network. Then make sure you
type in the web address exactly as it appears in this manual:
.
Choose WPA/WPA2-PSK under “Encryption Mode” (right above the password box)
to enable password protection.
I don’t see the Upstream WiFi name I want to extend in my list of networks.
If a network is very far away or very weak, the KING WiFiMax may not be able to see
KING WiFiMax to a location closer to your desired network.
Try reloading the page. If the page won’t load, make sure your device is still
connected to the KING WiFiMax. It may have disconnected during the reboot.
The KING WiFiMax doesn’t seem to extend the range of my Wi-Fi, or has trouble
Make sure all 4 antennas (3 if KING Swift is connected) are pointing up. If wall
mounting, antennas must be rotated to point up as well.
Certain types of obstructions (other vehicles, buildings, or large amounts of metal)
can reduce signal levels. Try relocating the KING WiFiMax.
NOTE:
KING WiFiMax can be reset by
pressing and holding
the reset button until the front
lights go out (15-20 seconds).
