28
Transportation
1. Switch the product off and disconnect the spark plug connector.
2. Adjust the height to the highest position as described above.
3. Attach transportation guards, if applicable.
4. Always transport the product by its handle (1).
5. Protect the product from any heavy impact or strong vibrations which may occur during transportation in vehicles.
6. Secure the product to prevent it from slipping or falling over, loss of fuel, damage and injury.
Troubleshooting
Suspected malfunctions are often due to causes that the users can
¿
x themselves. Therefore check the product using this section.
In most cases the problem can be solved quickly.
WARNING!
Only perform the steps described within these
instructions! All further inspection, maintenance and repair
work must be performed by an the problem yourself.
Problem
Possible cause
Solution
1. Engine does not start
1.1 Not enough fuel in fuel tank 1.2
Spark plug is wet
1.3 Spark plug is damaged 1.4 Spark
plug connector lose 1.5 Throttle lever
not in the correct position for the
prevailing conditions
1.6 Air
¿
lter is dirty
1.7 Spark plug loose
1.8 Spark plug gap is incorrect
1.9 Carburettor is
À
ooded with fuel
1.10 Faulty ignition module
1.4 Attach properly
1.5 Move throttle lever to correct position
1.6 Clean air
¿
lter
1.7 Tighten spark plug 20 N m
1.8 Set gap between electrodes
at 0.457~0.61mm
1.9 Remove air
¿
lter and pull recoil
starter handle continuously until
carburettor clears itself and install
air
¿
lter
1.10 Contact the service agent
2. Engine stops
2.1 Not enough fuel in fuel tank
2.2 Cutting device is blocked
2.1 Add fuel
2.2 Remove blockage
3. Engine dif
¿
cult to start or loses power
3.1 Dirt, water or stale fuel in the tank
3.2 Vent hole in fuel tank cap is clogged
3.3 Air
¿
lter is dirty
3.1 Drain fuel and clean tank. Fill tank
with clean, fresh fuel
3.2 Clean or replace fuel tank cap
3.3 Clean air
¿
lter
4. Engine operates erratically
4.1 Spark plug is defective
4.2 Spark plug gap is incorrect
4.3 Air
¿
lter is dirty
4.1 Install new, correctly gapped plug
4.2 Set gap between electrodes
at 0.457~0.61mm
4.3 Clean air
¿
lter
5. Engine idles poorly
5.1 Air
¿
lter is dirty
5.2 Air vents are clogged
5.3 Cylinder
¿
ns are blocked
5.1 Clean air
¿
lter
5.2 Remove debris from vents
5.3 Remove debris from cylinder
6. Engine skips at high speed
6.1 Gap between electrodes of spark
plug is too close
6.1 Set gap between electrodes
at 0.457~0.61mm
