KI6680, Mini Fiber Inspection Probe User Manual
Revision 4 Date: 31/05/2018 Page 8 of 12
5. Viewing Image on PC (via WiFi or USB connection)
5.1. Download Software
See section 2.3 for Software Compatibility on PC. Download the software,
“
Imaging Software-PC
”
from
https://www.kingfisherfiber.com/products/fiber-inspection-scope/ki-6680-fiber-inspection-probe
on
your PC. Install the software as per the prompted instructions.
5.2. Connect Instrument to PC
Turn on instrument by pressing down the
Main On/off Switch
. The blue LED near the switch will light up.
Instrument can now be connected to PC via WiFi or USB mode.
For WiFi mode connection:
Note:
To connect the instrument via WiFi to a Windows 10 PC with active firewall, you must
first “A
llow Firewall
Exception” on that PC to allow the imaging software
to communicate through the firewall.
Flip
WiFi/USB Selection Switch
to . Wait until the green LED has lighted up continually. Turn on WiFi of
your PC, connect it to instrument with the network name below,
Name: EasyGet_
x
x
represents the serial number of instrument.
Password: 12345678
If prompted with the message,
“Device connect failed”, check that
WiFi mode of instrument is enabled
and stable (indicated by the green LED,
WiFi Mode Status Indicator
which is lighted up continuously),
and the WiFi connection PC is enabled, and the correct connection type on PC display i.e. “WiFi” has
been selected. You may need to re-establish the connection.
For USB mode connection:
Flip
WiFi/USB Selection Switch
to the opposite side
of
. Connect instrument to PC using the supplied
USB cable.
If prompted with the message,
“Device connect failed”, check that
WiFi mode of instrument is disabled
(indicated by the dimmed
WiFi Mode Status Indicator
), instrument has been properly connected to PC
using the supplied USB cable, WiFi connection of PC is disabled, the correct connection type on PC
display i.e. “USB” has bee
n selected. You may need to re-establish the connection.
