6
MENU SCREENS AND THEIR FUNCTIONS
1. Press the menu button to cycle through the six different settings screens. Each screen is
explained below.
2. Holding the menu button for 6 to 7 seconds will allow you to change the settings on a
screen. Use the up or down buttons to change the values.
3.
Hold the menu button again to confirm your settings.
MAIN DISPLAY
Displays details about voltage and connections to the
PWM controller. (Not pressing any button for 10 seconds
will return you to this screen.)
FLOAT OR CV VOLTAGE
Accept power from the solar panel until the battery’s
voltage reaches the set value.
Default: 13.7V
DISCHARGE RECONNECT
Connect to the load when the battery’s voltage reaches
the set value.
Default: 12.6V
DISCHARGE STOP
Sever the connection to the load when the battery’s
voltage reaches the set value.
Default: 10.7V
WORK MODE
Control when the battery supplies power to the load.
24H – constantly provide battery power to the load.
1-23H – provide battery power to the load for the set
number of hours after the solar panel has stopped
receiving sunlight.
0H – provide power only when the solar panel is not
receiving sunlight.
BATTERY TYPE
Shows type of battery attached to the PWM controller.
b01 – Lead Acid/ AGM Sealed (default)
b02 - Gel
b03 - Dry Cell
