Glass Ember / MQ Ember Installation -MQRSP8 / RSP10-
IDV26 / IDV33 / IDV36
MQ DEALER ONLY
Spread glass or ember chunks onto tray and burner.
Ensure that layer of glass embers is not excessively thick as this will affect the flame pattern. See below.
MQRSP8
RSP10
(With Glass Retainer in Place)
Note:
Do not place all the glass embers onto the tray. Only use what is necessary.
Use care when placing glass embers near the pilot area so as not block or have the glass fall over the crossover
holes from the pilot to the burner, as delayed ignition can occur.
The following types of glass and other media are approved (Use of any other type other than listed below can
alter the performance of the unit and is not covered under warranty.):
Note:
Use only 1/2” glass material on the burner.
½” Ember Glass Material from American Fireglass
Maximum amount for
MQRSP8
Natural Gas is 5 lbs, Propane units 5 lbs.
Maximum amount for
RSP10
Natural Gas is 15 lbs, Propane units 15 lbs.
MQ Ember 3 -
Supplied for MQRSP8 Only
Three bags of Ember Chunks.
Discoloration of glass media may occur . This is not covered under warranty.
Pilot Shield* Must Be Kept Clear.
WARNING:
Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this appliance may result in property damage or personal injury.
*Pilot Shield should be visually inspected monthly for signs of deterioration due to flame exposure. Replace if necessary.
63
