ZCV34
Door and Glass Information
Glass Cleaning
It will be necessary to clean the glass periodically. During startup, condensation, which is normal, forms on the inside of the glass, and
causes dust, lint etc. to cling to the glass surface.
Also, initial paint curing can deposit a slight film on the glass. It is therefore recommended that initially the glass be cleaned two or three
times with a fireplace glass cleaner. After that, the glass should be cleaned two or three times a season depending on the
circumstances.
Glass Replacement
ZCV34N, ZCV34NE, ZCV34NE2, ZCV34LP, ZCV34LPE, ZCV34LPE2 must use Low E tempered glass. Must be 5mm thick.
ZCV34NH, ZCV34NHE, ZCV34NHE2, ZCV34LPH, ZCV34LPHE, ZCV34LPHE2 must use Robax ceramic or coated Neoceram glass.
Glass must be minimum 5mm thick.
To replace glass, clean all materials from the door frame. Scrape off old silicone all the way down to the metal. Using high-temp silicone
[rated up to 500°F (260°C)] apply a continuous bead of approximately 1/8”-3/16” to all four [4] sides of the frame. With the frame resting
on a flat surface, insert the new glass with a new gasket. Gently press the glass into the silicone. Be careful not to use excessive force
on the glass. Let the silicone dry for approximately 15-20minutes.
Use caution when removing broken glass. Wear gloves.
Removal of the Glass Door
1. Remove the door by unlatching the 2 top latches. Simply place 2 fingers in the grooves, and pull and lift upward slightly.
2. Once the top of the door is unlatched, pull it outward and lower it to unlatch the bottom.
3. To re-install, place the Bottom Door Ledge into the 2 Lower Latch assemblies first. Then swing the door closed to seal it against
the firebox cavity. Re-latch the Upper Latch assembly to secure the door to the appliance.
Spring Replacement
*Over time, the door latch springs (P/N#
36HB-123 for 51MQ-123A and P/N# 33IDV-
123 for 26IDV-123A) may need to be replaced
if tension is lost.
1. To replace latch spring, remove the 2 hex
screws (located in the firebox) that secure the
latch assembly in place.
2. Once the screws are removed the latches will
slide out of place.
3. Remove the locknut from the latch assembly
and replace the spring. Re-tighten the locknut
until 2 thread turns are beyond the locknut.
This is critical for proper tension. Replace
latch assembly.
⚠
Cautions and Warnings
•
Do not clean when the glass is hot.
•
The use of substitute glass will void all product warranties (see
Glass Replacement
in this section).
•
Care must be taken to avoid breakage of the glass.
•
Do not operate this fireplace without the glass front or with a broken glass front.
•
Do not strike or abuse the glass.
Upper Latch
Assembly
51MQ-123A
Lower Latch
Assembly
26IDV-123A
Glass Door
Frame
31
