1. Clean the treadmill
• Shut down and disconnect the power from the treadmill.
• Wipe off the dust and smudges from the main frame and the motor over with a 100%
cotton rag dipped with a little of mild detergent. Do not spray the cleaner directly onto
the running belt or use the acid and corrosive cleaners while cleaning the surface of the
running belt. Do not wipe under the running belt. It is normal that there may be dust and
smudges on the rear ground after the product is used for a period of time. Please
remove the dust and smudges.
• Running belt inclined left: Turn the left adjustment screw 1/4 circle clockwise.
• Running belt inclined right: Turn the right adjustment screw 1/4 circle clockwise.
• Slip running belt: Turn the left and right adjustment screws clockwise at the same time a
half circle to run the running belt for a period of time (1~2 minutes) to observe the
centering situation. If necessary, please adjust it again.
• Shut down and pull out the power cord of the treadmill.
• Lift the edge of the running belt and apply silicone oil to the inner surface . Power on the
treadmill again to run the running belt at 4km/h for 10-20 seconds
• 5-10 ml of silicone oil is needed for one time of lubrication. If the lubrication is applied
too much, the belt will slip and affect normal use.
• Add the silicone oil every 3 months.
06 Safety Instructions
07 Maintenance and Servicing
15
16
Do Not Step to Prevent Being
Involved.
Keep the horizontal sight to void
visual dizziness.
Do Not Step to Prevent Being
Involved.
For Single-user only.
Warning: please make sure the
running surace comes to a complete
stop before folding. Do not fold with
power on. A folded treadmill should
not be operated.
2. Slip running belt and correction
3. Lubricate the running belt
Horizontal sight
Do not walk sideways.