DE90i-S, Rev. A00
Kingston Technology Company
Installation
11
Installing the Receiving Frame
The drive should be installed into the carrier before installing the receiving frame into the
mounting bay of a computer or expansion chassis.
NOTE:
Use a #2 Phillips screwdriver during this procedure.
1.
Turn off power to the computer.
2.
Open the computer system according to the manufacturer’s instructions. If
necessary, temporarily remove any expansion boards that may make installation
difficult.
3.
Select the unit ID number on the rear of the receiving frame by placing jumpers on
the appropriate (J4) pins. Refer to Figure 7 and to Table 3 for additional information.
Table 3 - Receiving Frame Mother Board Connector J4 Pin Configuration
Pin 1
RESERVED
Pin 11
RESERVED
Pin 2
RESERVED
Pin 12
RESERVED
Pin 3
RESERVED
Pin 13
RESERVED
Pin 4
RESERVED
Pin 14
RESERVED
Pin 5
RESERVED
Pin 15
Ground
Pin 6
RESERVED
Pin 16
ID2
Pin 7
RESERVED
Pin 17
Ground
Pin 8
RESERVED
Pin 18
ID1
Pin 9
RESERVED
Pin 19
Ground
Pin 10
RESERVED
Pin 20
ID0
Figure 7: SCSI ID Select Pin Configuration on Receiving Frame Mother Board (J4)
Ground
0419
Receiving Frame
Mother Board
Connector J4
Installed
at Factory
SCSI ID = 0
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
ID1
ID2
ID0
ID NUMBER
Reserved
19
20
1
13
2
14
ID0
ID1
ID2
Summary of Contents for DATA EXPRESS DE90
Page 1: ...Kingston Technology DE90 DATA EXPRESS Removable 8 Bit Single Ended SCSI Drive Enclosure...
Page 5: ...iv Kingston Technology Company DE90i S Rev A00...
Page 11: ...6 Introduction Kingston Technology Company DE90i S Rev A00...
Page 21: ...16 Appendix A Attaching the On Off Key Kingston Technology Company DE90i S Rev A00...