DE90i-S, Rev. A00
Kingston Technology Company
Appendix A - Attaching the On/Off Key
15
Appendix A - Attaching/Removing the
On/Off Key
The DE90 comes from the factory with a power/lock key which can be attached to the
locking mechanism. Follow the steps below to attach the key.
1. Make certain power is off to the receiving frame.
Locate the rectangular shaped key/lock
mechanism access hole on the inside of the
receiving frame. Note that the pawl is in an
upright position.
Insert the key into the lock. (Skip this step if the
key is already fixed to the lock.)
2. Rotate the key 90 degrees counter-clockwise so
that the pawl is visable in the access hole as
shown in the figure at left.
3. Using the provided adjustment tool, unscrew and
remove the pawl from the access hole.
4. Rotate the key 180 degrees clockwise (or
counter clockwise).
5. Reinstall the pawl into the access hole with the
adjustment tool.
The key/lock has now been reconfigured.
Figure A-1: Reconfiguring the Key/Lock Mechanism
A
B
C
0418
Pawl
Access
Hole
Key/Lock
90
Degrees
180
Degrees
Summary of Contents for DATA EXPRESS DE90
Page 1: ...Kingston Technology DE90 DATA EXPRESS Removable 8 Bit Single Ended SCSI Drive Enclosure...
Page 5: ...iv Kingston Technology Company DE90i S Rev A00...
Page 11: ...6 Introduction Kingston Technology Company DE90i S Rev A00...
Page 21: ...16 Appendix A Attaching the On Off Key Kingston Technology Company DE90i S Rev A00...
