MobileLite is a USB card reader with three memory card expansion slots. The slot on side A supports,
SD, SDHC, MMC, MMC
mobile
, RS-MMC, and MMC
plus
. The slots on side B support microSD, MMC
micro
and miniSD. When inserted into a computer’s USB port, the MobileLite will appear in My Computer
with three drive letters (i.e. G:\, H:\, I:\). Data transfer is a drag-and-drop operation. For MobileLite
FAQs, go to kingston.com/support/faqs/dmr.
Inserting and removing the media into the MobileLite:
1. Open the card slot cover (#1).
2. Insert the media into the card slot (#2) with the metal contacts facing down.
3. To remove the media use the eject tab (#3).
4. Close the card slot cover for protection.
Inserting the strap (Optional):
1. With the cap off, feed the strap (#4) through the hole on the side of the USB cap.
2. Feed the strap through the hole on the side of the MobileLite.
3. Create a loop with the strap and insert the USB cap into the opening.
4. Tighten the strap by pulling on the USB cap.
An optional five-inch USB extension cable is included with the MobileLite reader. Use this cable to
insert the reader into USB ports which may have space restrictions.
