10
Installation
StorCase Technology, Inc.
DE75i-A User's Guide - Rev. C01
Figure 6: Typical AT/IDE Drive Connections
Typical AT/IDE drive jumper positions are shown in Figure 6.
C/D
The darkened pin in the figure above is connected to Pin-1 of the provided wire
wrap connector.
DSP
Install the jumper in the DSP position as shown in Figure 6.
Install the wire wrap connector onto J3 on the drive carrier circuit board.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
All manuals and user guides at all-guides.com