19
3. Heater stand and location
• The heater is for outdoor use only.
Always ensure that adequate fresh air ventilation is provided.
Always maintain proper clearance to combustible materials.
• Heater must be placed on level firm ground.
• Never operate heater in an explosive atmosphere like in areas where gasoline or other
flammable liquids or vapors are stored.
• Keep a distance of at least 2 metres from Combustible Materials.
• After every use, turn off the gas valve on the cylinder.
• The heater should be protected from strong winds by braking the wheel
4. Gas requirements
• The pressure regulator and hose assembly to be used must conform to local standard codes.
• The installation must conform to local codes, or in the absence of local codes, with the standard for the storage and
handling of liquid petroleum gases.
• A dented, rusted or damaged propane tank may be hazardous and should be checked by your tank supplier.
Never use a propane tank with a damaged valve connection.
• The propane tank must be arranged to provide for vapor withdrawal from the operating cylinder.
• Never connect an unregulated propane tank to the heater.
• To change the gas cylinder in a amply ventilated area, away from any ignition source (candle, cigarettes, other
flame producing appliances, ...).
• To check that the regulator seal is correctly fitted and able to fulfil its function.
• To not obstruct the ventilation holes of the cylinder housing.
• Instructions in case of gas leakage; for instance : in the event of gas leakage, the appliance shall not be used or if
alight, the gas supply shall be shut off and the appliance shall be investigated and rectified before it is used again.
• The recommended frequency of checking the tubing or the flexible hose (at least once per month and each time
the cylinder is changed). If it shows signs of cracking, splitting or other deterioration it shall be exchanged for new
hose of the same length and of the equivalent quality.
5. Regulator, hose and cylinder
This appliance is only suitable for use with low-pressure butane or propane gas and fitted with the appropriate
low-pressure regulator via a flexible hose. The hose should be secured to the regulator and the appliance with hose
clips or nut. This barbecue is set to operate a 28 mbar regulator with butane gas and a 37mbar regulator with
propane gas and a regulator with butane /propane mixture at 50mbar and a regulator with butane/propane mixture
at 30mbar. Use a suitable regulator certified to BSEN16129:2013.
Please consult your LPG dealer for information regarding a suitable regulator for the gas cylinder.
Regulator and hose
Use only regulators and hose approved for LPG at the above pressures. The life expectancy of the regulator is
estimated as 5 years. It is recommended that the regulator is changed within 5 years of the date of manufacture.
The use of the wrong regulator or hose is unsafe; always check that you have the correct items before operating
the heater.
The hose used must conform to the relevant standard for the country of use. The length of the hose must be
0.5 meters (maximum). Worn or damaged hose must be replaced. Ensure that the hose is not obstructed, kinked,
or in contact with any part of the heater other than at its connection.
The hose should not be twisted or kinked when attached to the gas cylinder.
No part of the hose should touch any part of the appliance. So site the cylinder out to the left hand side of the
appliance at the maximum distant permitted by the hose length.
E
N
GB-BAHAG KS FEUERSTELLE MANUAL RZ.qxp 20.04.22 12:14 Seite 19
