7) Small bottle of BLUE Loc-tite or equivalent thread locker. Must be BLUE thread locker and
non- permanent bond, not RED!
8) Heat gun for shrink tubing on solder connections ( soldering iron may also be used)
___________________________________________________________________________
4) Before You Begin
Please read entire manual before you begin
so you have an overall idea of what to do.
Check all parts. If you find any missing or defective parts, contact your local HobbyTechnik
dealer or HobbyTechnik.
Your
Slow Hawk 2
box should contain the following items:
1)
One fuselage plate with assembled gearbox, motor, connecting rods.
2)
One main parts bag.
3)
Two main carbon wing spars with aluminum hinge ferrules and vinyl end caps.
4)
Two smaller diameter carbon rods with ball link housing ends.
5)
One wingsail and one tail assembly.
6)
One instruction manual CD.
The main parts bag listed above should contain the following parts:
1) Small nylon tie straps for neatly gathering up servo wires
2) Adhesive backed velcro for battery mounting
3) Ten small 2mm screws for mounting
servos, optional ESC switch, and HS-55 tail mount
4) Approximately 14 neoprene O-rings
5) Two #5-40 X 3/4" screws for wing hinge axles
6) G-10 cross shaped tail piece (for HS-55 servo use only)
7) 2mm flat head screw for elevator pushrod
8) Heat shrink tubing for solder connections
___________________________________________________________________________