Installation and initial operation
01.04.2020
57
16. Change the oil flow so that the cross-hairs lie on the 4th point.
17. Increase the valve current until the hydraulic pump on the excavator can be
heard to start pumping:
Too high results in increased fuel consumption.
Too low results in the speed of the tiltrotator being too low.
18. Repeat steps 10 - 11 for the 5th and 6th points in the chart whilst
simultaneously carrying out tilting and rotating functions.
19. Couple an attachment with a large volumetric flow and repeat steps 10 - 11
for one of the top points in the chart. In doing so, simultaneously carry out
tilting, rotating and extra functions.
20. If there is no attachment available, extrapolate the curve out to 100% as an
S-shaped characteristic curve.
If the roller is moved and in doing so there is too much or too little oil, the
distribution of the oil quantity for the individual functions can be adapted.
1. Tap the
Functions
button in the feeder menu.
2. Tap the
Tilt
button.
3. Adapt the values for tilt left
Tilt left
and tilt right
Tilt right
.
4. Likewise, adapt the values for
Extra 1
,
Extra 2
,
Direct Mode
and
NOO
in the
same way.
Adapt the oil flow
