KINTECH ENGINEERING
ORBIT 360 | USER GUIDE
101
2. Extract the old SIM card by gently pushing it in until it clicks.
3. Turn on the logger (without SIM card).
4. Configure the new SIM PIN code by following the instructions in sections
5. Wait until the next recording period for the configuration change to become
effective (refer to section 4.2.4). If the logger is turned off before the logger
makes the SD recording, the changes will be lost.
6. Turn off the logger.
7. Insert the new SIM card.
8. Turn on the logger.
Remark:
APN parameters can only be modified by using the Atlas software and
uploading the new settings to the SD card.
7.6.2
Sensor replacement
If a sensor replacement alters the sensor´s model, the logger´s channel should be
reconfigured. To do it directly from the logger´s keypad, the installer needs to follow
the below navigation steps:
1. Press SET at the logger´s keypad to turn on the screen and then up or down to enter
the main menu;
2. Select the Sensor Model menu with the right arrow;
3. Navigate with the keypad´s up and down arrows until the channel respective to the
sensor replaced is highlighted;
4. Press keypad´s right arrow to enter and view the channel´s settings;